- 弯曲模量 [MPa]: 4.00
| Physical Properties | Metric | English | Comments | ||
|---|---|---|---|---|---|
| Specific Gravity | 1.42 g/cc | 1.42 g/cc | ISO 1183 | ||
| Water Absorption | <= 0.50 % | <= 0.50 % | 23°C/24h | ||
| Linear Mold Shrinkage | 0.010 - 0.016 cm/cm | 0.010 - 0.016 in/in | |||
| Mechanical Properties | Metric | English | Comments | ||
| Tensile Stress | 95.0 MPa | 13800 psi | |||
| Elongation at Yield | 4.0 % | 4.0 % | |||
| 6.0 % | 6.0 % | flexural | |||
| Modulus of Elasticity | 4.50 GPa | 653 ksi | |||
| Flexural Strength | 145 MPa | 21000 psi | |||
| Flexural Modulus | 4.00 GPa | 580 ksi | |||
| Charpy Impact, Notched | 0.500 J/cm² | 2.38 ft-lb/in² | ISO 179 1eA | ||
| Electrical Properties | Metric | English | Comments | ||
| Surface Resistance | >= 1.00e+12 ohm | >= 1.00e+12 ohm | |||
| Insulation Resistance | >= 1.00e+12 ohm | >= 1.00e+12 ohm | |||
| Thermal Properties | Metric | English | Comments | ||
| Maximum Service Temperature, Air | 250 °C | 482 °F | |||
| 260 °C | 500 °F | short term | |||
| Deflection Temperature at 1.8 MPa (264 psi) | 150 °C | 302 °F | |||
| Processing Properties | Metric | English | Comments | ||
| Processing Temperature | 390 °C | 734 °F | mass temp | ||
| Nozzle Temperature | 360 - 380 °C | 680 - 716 °F | |||
| Zone 1 | 360 - 370 °C | 680 - 698 °F | |||
| Zone 2 | 380 - 390 °C | 716 - 734 °F | |||
| Zone 3 | 390 - 400 °C | 734 - 752 °F | |||
| Mold Temperature | 170 - 190 °C | 338 - 374 °F | |||
| Drying Temperature | 120 °C @Time 21600 - 28800 sec | 248 °F @Time 6.00 - 8.00 hour | or | ||
| 150 °C @Time 10800 - 21600 sec | 302 °F @Time 3.00 - 6.00 hour | Dehumidifying dryer | |||
| Descriptive Properties | |||||
| Color | beige red | ||||