PA6 B3WGM 24HP BK23210 20%玻璃、

 PA6 B3WGM 24HP BK23210 性状为半透明或不透明乳白色结晶形聚合物，具有可塑性。密度1．15g／cm3。熔点252℃。脆化温度-30℃。热分解温度大于350℃。 连续耐热80-120℃,平衡吸水率2．5％。能耐酸、碱、大多数无机盐水溶液、卤代烷、烃类、酯类、酮类等腐蚀，但易溶于苯酚、甲酸等极性溶剂。具有优良的耐磨性、自润滑性，机械强度较高。但吸水性较大，因而尺寸稳定性较差。

Physical Properties	Metric	English	Comments
Density	1.37 g/cc	0.0495 lb/in³	ISO 1183
Water Absorption	6.9 - 7.5 %	6.9 - 7.5 %	Saturation; ISO 62
Moisture Absorption at Equilibrium	2.1 - 2.5 %	2.1 - 2.5 %	23°C; 50% RH; ISO 62
Viscosity Measurement	123	123	ISO 307
Melt Flow	116.45 g/10 min @Load 5.00 kg, Temperature 275 °C	116.45 g/10 min @Load 11.0 lb, Temperature 527 °F	ISO 1133
Mechanical Properties	Metric	English	Comments
Tensile Strength, Yield	115 MPa	16700 psi	50 mm/min; ISO 527-1/-2
Elongation at Yield	5.0 %	5.0 %	50 mm/min; ISO 527-1/-2
Modulus of Elasticity	3.60 GPa	522 ksi	ISO 527-1/-2
Charpy Impact Unnotched	5.00 J/cm² @Temperature 23.0 °C	23.8 ft-lb/in² @Temperature 73.4 °F	ISO 179/1eU
Charpy Impact, Notched	1.50 J/cm² @Temperature 23.0 °C	7.14 ft-lb/in² @Temperature 73.4 °F	ISO 179/1eA
Electrical Properties	Metric	English	Comments
Volume Resistivity	1.00e+10 ohm-cm	1.00e+10 ohm-cm	IEC 60093
Surface Resistance	1.00e+10 ohm	1.00e+10 ohm	IEC 60093
Dielectric Constant	6.2 @Frequency 1.00 Hz	6.2 @Frequency 1.00 Hz	IEC 60250
Dissipation Factor	0.20 @Frequency 1.00e+6 Hz	0.20 @Frequency 1.00e+6 Hz	IEC 60250
Thermal Properties	Metric	English	Comments
Specific Heat Capacity	1.30 J/g-°C	0.311 BTU/lb-°F
Melting Point	220 °C	428 °F	DIN 53765
Maximum Service Temperature, Air	180 °C	356 °F
Processing Properties	Metric	English	Comments
Melt Temperature	250 - 290 °C	482 - 554 °F	Injection-molding/Extrusion
Mold Temperature	70.0 - 90.0 °C	158 - 194 °F	Injection-molding
Descriptive Properties
Color	BK 23210
Commercial Status	Europe